Tel: 01482 868321

Sales enquiries : sales@hodgsonsealants.com
Technical enquiries : technicalservices@hodgsonsealants.com

HS20 Clear

HS20 Clear is a single component, moisture-curing, sealant and adhesive based on Hodgson Hybrid Polymer Technology. It is an invisible sealant that it offers outstanding performance across a wide variety of industrial applications. It has excellent adhesion to glass, timber, metals, brickwork, most plastics and concrete and does not normally require a primer. PAS 23/24 certified for SBD doorset assemblies. Crystal clear, transparent, elastic sealant and adhesive. PAS23/24 certified for SBD assemblies. Tested to EN 15651-1:F-INT.

HS20 Clear is a paintable sealant that has been specifically formulated to seal typical joints where a strong, invisible bond and high movement is required.

APPLICATIONS

Ideal for bonding where a high strength, elastic and crystal clear finish is required.

  • Excellent adhesion on most materials
  • Very easy to tool and weather
  • UV resistant
  • Crystal clear
  • Neutral system, free from isocyanates and silicones.
  • Good movement accommodation between dissimilar materials

PROPERTIES

Application temperature range: +5°C to +30°C

Curing rate: Cures at a rate of 3-4mm in 24 hours at 23°C @ 50% RH. Lower temperatures and drier conditions will result in a slower rate of cure.

Shelf life: 9 months in original unopened packaging at temperatures of +5°C to +25°C.

Skinning time: Skin forms after approximately 30 minutes.

Working time: Approximately 30 minutes depending on conditions.

INSTRUCTIONS

Joint design: Please consult the Technical Information Sheet entitled ‘Joint design for cartridge based products’ prior to application.

Surface preparation: All surfaces must be clean, dry and free from frost, grease and loose materials. Apply primer if required. Install bond breaker to prevent bond at base of joint where necessary. Most substrates only require priming if testing indicates a need or where sealant will be subjected to water immersion after cure. Cut the top of the screw thread off the cartridge and screw on the nozzle. Cut nozzle to correct diameter for joint size. Apply using a skeleton or powered gun into the joint ensuring good contact with surfaces.In deep joints, the use of Hodgson Backing Rod is essential to ensure good joint formation. In situations where an especially neat finish is required, use masking tape to cover the face edges of the joint and remove immediately once tooling has been completed.

Tooling: Tool immediately after sealant has been applied within the working time for the product.

Buy now

From £7 (excl. VAT)

Download product data sheet Download safety data sheet